New Jersey Hunters banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2,835 Posts
Discussion Starter · #1 ·
Have a 96 merc 9.9 impeller problem. The impeller and the whole kit is new. But still not pumping water thru motor. It blows steam. The water tube is connected inside the shaft. Water however is being pumped out of 2 holes where the shift linkage rod goes down into the shaft by the lever where u would lift to tilt motor. Any suggestions? I have tried everything made sure the water outlet was clear took it apart 5 times getting sick of finding nothing!
 

·
Registered
Joined
·
9,711 Posts
sounds like the other end of the tube has come off as you are getting water flow.

with the mercs when you you pull the lower unit it can be a PIA to make sure the water tube is right or you could have an issue with the tube itself
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top