[petdetective1]

cant get arrows to spin-up after insyalling inserts, on axis fmj's any suggestions

 

[bowhunter444]

What do mean by spin up. Is it you can't get the points in? if so you got epoxy or glue inside the insert. If that is the case you need to get a correct tap and re thread the insert if epoxy, if glue reheat and screw in point.

 

[4lifer]

what bowhunter444 said.take n arrow to a hardware store n get a tap that that fits your insert n just retap it.i shoot axis w/HIT n i have a tap for mine but i cant see the size on the tap [wallmad]

 

[petdetective1]

Sorry for not being clear, no epoxy on the threads it seems the broad heads wont spin clean, they wobble

 

[bowhunter444]

broad heads wont spin clean, they wobble

Then you have bad inserts they probally were not machined right from the factory.

 

[4lifer]

hows the cut look on the end of the shaft could be n uneven cut .other wise i'm no good at broahead tunning which also could be the case

 

[bowhunter444]

Try changing the head to diffrent arrow I take one head and try it in a couple arrows to find the best match once matched that head is marked for that arrow.

 

[jerseyhunter]

Are you putting it on an arrow spinner? The inserts are not in square or the arrow shaft is bent.